Emergency Plumber Eveleigh

An emergency plumbing service in Eveleigh covers urgent faults that risk property damage, safety hazards, or loss of essential water and gas supply, broken pipes flooding a room, gas leaks requiring immediate isolation, or a completely blocked main drain backing up into the home. If the first visit confirms straightforward access and the required parts are on the truck, many urgent repairs are completed the same day; if inspection reveals structural damage or parts need ordering, we explain the options and provide a fixed quote before any additional work proceeds.

Active leaks are stressful. The priority is getting a fully licensed plumbing technician onsite to isolate the water supply, locate the source, and stop further damage. In Eveleigh's mix of period conversions and modern apartments, leaks can be hidden behind plasterboard or under concrete slabs, which is why we use electronic ultrasonic leak location to pinpoint the fault without unnecessary demolition. Once located, the repair is scoped, quoted, and completed with minimal disruption to finishes.

Burst pipes typically occur where old galvanised steel or copper has corroded, or where ground movement has stressed a joint. If you're seeing water pooling or hear running water when all taps are off, the main water valve (usually near the front boundary or under the kitchen sink) should be turned off to reduce flooding while the plumber is on the way. We'll confirm the affected section, replace the damaged pipe, and test the system before leaving.

A gas smell is urgent. If you detect the distinctive odour or hear hissing near an appliance, don't operate electrical switches or ignition sources. Ventilate the area, turn off the gas at the meter if safe to do so, and call us immediately. Our licensed gas fitters (covered under Licence 305428C) will locate the leak using combustible gas detectors, repair or replace the faulty section, and conduct a pressure loss test to confirm the system is gas-tight before reconnection. All gas work in NSW requires a compliance certificate, which we issue on completion.

Blocked drains that cause sewage to back up into the home require urgent attention to prevent health risks and property damage. We use hydro jetting (hydro-jetting at up to 5,000 PSI) to clear the obstruction and CCTV drain cameras to confirm what caused it, tree roots, collapsed pipe sections, or solidified grease. If the camera shows structural damage, drain relining or excavation may be required; we explain the findings and provide a fixed quote before proceeding.

Our emergency pricing is upfront and fixed by the job, not by the hour. That means the quote provided after onsite assessment is the final price, with no surprise charges added once work starts. Call-out fees vary by suburb and urgency; confirm the call-out fee status when booking. For paying jobs, mention "web55" to receive $55 off (limited to one use per person). We accept all major credit cards including Visa and Mastercard.

Fixed Today Plumbing has been operating across Sydney for over 15 years, with a near-perfect 5-star rating based on 800+ verified customer reviews. Our technicians arrive in uniform, can identify themselves before entry, and use drop sheets and boot covers to protect floors during work. We clean up the work area at the end of the job and verify the repair is holding before leaving. All workmanship is backed by our Lifetime Labour Warranty, and manufacturer warranties apply to any parts or appliances installed.

A dripping tap in Eveleigh typically results from a worn washer, damaged O-ring, or corroded valve seat inside the tap body. Left unattended, a steady drip can waste hundreds of litres per week and drive up water bills, while also staining sinks and encouraging mould growth in damp areas.

We diagnose the fault by disassembling the tap, inspecting the internal components, and identifying which parts need replacement. Most tap repairs involve replacing the washer or cartridge and resealing the assembly, which restores a watertight seal and stops the drip. If the tap body itself is corroded or cracked, replacement is more reliable than attempting a repair that may fail again within months.

Mixer taps and modern cartridge-style taps require specific replacement parts, which we carry on the truck for common brands. Once the repair is completed, we test the tap under normal operating pressure to confirm there's no residual leak and the flow rate is correct. The work is backed by our Lifetime Labour Warranty on workmanship.

Shower faults in Eveleigh typically involve low water pressure, blocked showerheads, leaking mixer valves, or failed waterproofing behind tiles. Low pressure is often caused by sediment buildup in the showerhead or a partially closed isolating valve, both of which are straightforward to clear or adjust. If pressure is low throughout the property, the issue may be with the main supply or pressure regulator, which requires further investigation.

Leaking shower mixers usually result from worn cartridges or O-rings inside the tap body. We disassemble the mixer, replace the faulty components, and test under operating pressure to confirm the leak is stopped. If water is seeping through the tile grout or pooling outside the shower screen, that indicates failed waterproofing, which requires resealing or, in severe cases, retiling the impacted area after the membrane is repaired.

Blocked shower drains are cleared using mechanical drain snakes or high-pressure jetting, depending on the obstruction type. Hair and soap buildup are the most common causes, and regular clearing prevents slow drainage from escalating into a complete blockage. Once cleared, we test the flow rate and confirm the drain is running freely.

Gas fitting work in Eveleigh covers new gas appliance installations, gas leak detection and repair, and compliance testing for altered or repaired gas systems. All gas work in NSW must be performed by a fully properly licensed gasfitter (covered under our Licence 305428C), and a compliance certificate is issued on completion to verify the installation meets AS/NZS 5601.1 safety standards.

If you detect a gas smell, hear hissing near an appliance, or notice unusual soot buildup on burners, that indicates a potential leak or appliance fault. The distinctive "rotten egg" odour in gas is an added mercaptan signal designed to alert occupants. Do not operate electrical switches or ignition sources if you suspect a leak, ventilate the area, turn off the gas at the meter if safe to do so, and call us immediately for an urgent assessment.

We use combustible gas detectors and thermal imaging to locate leaks behind walls or under floors, then repair or replace the faulty section. After any gas repair or new installation, we conduct a pressure loss test to confirm the system is gas-tight before reconnecting the supply. This involves pressurising the line and monitoring for pressure drop over a set period, which is the industry standard for verifying safe operation.

New gas appliance installations (cooktops, ovens, hot water systems, or heating units) require correct sizing of gas lines, secure connections, and verification that the appliance is receiving the correct gas pressure. We test ignition, flame quality, and safety shut-off functions before issuing the compliance certificate. Manufacturer warranties apply to the appliance, and our Lifetime Labour Warranty covers the installation workmanship.